Power Outage at Home: Is It the Grid or Do You Need an Electrician?
If you are searching for an electrician for a power outage, pause for two minutes. Most outages are the grid's problem, not your wiring's — an electrician cannot fix a dead line on the pole. The check below shows which side of the meter the fault sits on.
The short answer: If the whole street is dark, it is a grid outage — report it to your utility, not an electrician. If only your home is dark while neighbours have power, check the main breaker and GFCI outlets first; if the breaker will not reset, or you smell burning, call a licensed electrician.
Is it the grid or your home? The two-minute check
Work through the four steps in order; stop at the first that explains the outage.
- Look outside. Neighbours' homes and streetlights dark too? The fault is on the grid — skip the rest and report it to your utility (table below).
- Check the meter. Read the display — do not open anything. A blank display while the street looks dead points to a supply problem; a live display with a dark house points inside your home.
- Check the main breaker. Open the panel door (the door only — never the cover behind it). A tripped breaker sits halfway between on and off. Push it fully to off, then back to on.
- Check the GFCI outlets. If only part of the home is out — a bathroom, the kitchen counters, the garage — find the GFCI outlet on that circuit and press Reset. One GFCI protects whole runs of sockets, so one trip darkens several rooms.
Stop and call for help instead if: a line is down, you smell burning, you hear buzzing from the panel, or the floor near the panel is wet. Leave the area and call 911. Oncor's instruction: never approach, touch, or move a downed power line, or anything in contact with one.
Who to call — the decision table
| What you see | Most likely cause | Who to call |
|---|---|---|
| Whole street or neighbourhood dark | Grid outage | Your utility (table below) |
| Only your home dark, neighbours lit | Tripped main breaker, failed meter base, or a fault on the service line | Check the main breaker; then the utility, or an electrician if it won't reset |
| Part of the home out | Tripped breaker or tripped GFCI on one circuit | Reset it yourself; an electrician if it trips again under load |
| Half the home out, large appliances dead | A lost leg of the supply — can sit on either side of the meter | Utility first; an electrician if the utility clears its side |
| Flickering plus a burning smell, buzzing or scorch marks | Loose connection — a fire risk | Switch the circuit off if safe; call an electrician now. Smoke or flames: leave and call 911 |
One Texas wrinkle decides half of these calls: in Houston and Dallas–Fort Worth, the company named on your bill is a retail provider — it sells power but owns no wires and runs no crews. The delivery utility in the bill's delivery-charges line restores your power. Austin Energy, CPS Energy and El Paso Electric each do both jobs in their cities. The Public Utility Commission of Texas keeps the official list of every utility's outage map and reporting number.
Texas: who owns the wires in your city
| City | Who owns the wires | Report an outage | Outage map |
|---|---|---|---|
| Houston | CenterPoint Energy | Report online via the Outage Tracker or Power Alert Service | Outage Tracker |
| Dallas | Oncor | 888-313-4747, or text OUT to 66267 | Oncor Storm Center |
| Fort Worth | Oncor | 888-313-4747, or text OUT to 66267 | Oncor Storm Center |
| Austin | Austin Energy | 512-322-9100, or text OUT to 287846 | Austin Energy outage map |
| San Antonio | CPS Energy | 210-353-4357 (210-353-HELP) | CPS Energy outage map |
| El Paso | El Paso Electric | (915) 877-3400 | EPE outage center |
Some addresses near these metros sit in a neighbouring territory — AEP Texas (report at aeptexas.com/outages or 866-223-8508) or a cooperative. The delivery line on your bill settles it: that name is your utility, whatever city you live in.
What to check yourself, safely
The two resets above are the whole of the safe list, with two refinements. A breaker that trips again immediately stays off — do not keep resetting it. For a GFCI, unplug what was running before you press Reset, then plug items back one at a time to find the culprit.
Everything past the panel door is not yours to open. Never remove the panel's inner cover, never touch the meter or pull it from its base, and never touch the service drop — the cable from the pole to your roof. If a storm has pulled the meter base or weatherhead off your wall, that equipment is the homeowner's: Oncor states an electrician must repair it before the utility can restore power.
When it is an electrician's job
Call a licensed electrician when:
- A breaker trips again as soon as you reset it, or will not reset at all
- Part of the home is still out after the utility confirms its side is healthy — a lost leg inside the panel
- You smell burning, hear buzzing at the panel, or see scorch marks
- The meter base, weatherhead or cable mast on your home is storm-damaged
- One circuit keeps failing under normal load — the pattern behind many flickering lights problems too
Texas electrical work must be done by or through a licensed electrical contractor (Occupations Code §1305.151). Before you hire, run the two-part check our electrician pages teach: in TDLR License Search, find the company's Electrical Contractor record (status Active) and read its "Master:" line naming the Master Electrician of Record — the number on the truck is that number with a TECL prefix — then pull the master's own Master Electrician record and confirm it is Active too. The contractor must also carry liability insurance of at least $300,000 per occurrence, filed at TDLR. Find yours: electricians in Houston, Dallas, Fort Worth, Austin, San Antonio, El Paso.
What an electrician visit costs
Ask about the call-out or diagnostic fee before you book, and get it in writing — fees vary by company, and we do not publish a figure we cannot tie to a named source. The repair the diagnosis often ends at is priceable: if the fault is a failing main panel, our worked example for a 200-amp panel upgrade in Houston — parts, labour and permit, from named product prices and Texas wage data — comes to $1,090–$1,470 (full build-up in the electrician cost guide). Repairs on the utility's side — wires, pole transformer, service drop up to your connection point — are the utility's to make, not yours.
After the power returns
- Food first. Keep fridge and freezer doors closed. FoodSafety.gov puts a closed refrigerator at up to 4 hours of safe cold; a full freezer holds about 48 hours, a half-full one about 24. After 4 hours without power, throw out refrigerated perishables — and never taste food to test it.
- Still dark when the map says restored? Report it again. Oncor asks customers still out after checking their breaker to re-report — a second fault on your line may not show until you do. Note which breaker tripped and what was running; an electrician will ask — it shortens the diagnosis.
- Think about surge protection. Returning power can arrive with a surge. A whole-home surge protector at the panel runs $270–$320 installed on our worked example (from the manufacturer's list price — retailers may charge less); see the electrician cost guide.
FAQ
Who do I call if only my house has no power?
Check your main breaker first. If it is on and holding, report the outage to your utility — a failed fuse or service connection can darken one home on a lit street. If the breaker will not reset, or the utility confirms its equipment is healthy, the fault is inside your home: an electrician's job.
Why is only part of my house without power?
Usually one tripped breaker or one tripped GFCI protecting several sockets — reset both first. If roughly half the home is out and 240-volt appliances (oven, dryer, AC) are dead while some lights work, one leg of your supply has failed; start with the utility.
My breaker keeps tripping — is that an emergency?
A breaker that trips once under heavy load and resets cleanly is doing its job. One that trips again immediately, trips with nothing running, or comes with a burning smell or heat at the panel is a fault — leave it off and call an electrician the same day.
How do I report a power outage in Texas?
To the delivery utility that owns the wires at your address, not the company that bills you — unless you are in Austin, San Antonio or El Paso, where one company does both. Use the table above, or the PUC of Texas storm page.
Can an electrician fix a power outage?
Only the house side of one. An electrician repairs your panel, breakers, wiring and the meter base on your wall; the utility repairs everything from the pole to your home's connection point. The two-minute check tells you which side your outage is on.
Call for a quote or request an electrician in your city — the city pages above carry local licence checks and costs.
Safety line. Never touch a downed power line or anything touching one, and never open your meter base or panel cover. For sparks, smoke or fire, leave the home and call 911.
Disclaimer. The costs on this page are estimates only, computed from the sources below with their assumptions printed next to them. Your final price depends on your home, the job and the scope you agree, and costs vary by job, material and location. Always confirm a contractor's licence and insurance before work starts.
Sources. Oncor Storm Center (oncor.com); CenterPoint Energy reporting page (centerpointenergy.com); Austin Energy (austinenergy.com) and City of Austin outage page; CPS Energy contact page (cpsenergy.com); El Paso Electric power restoration page (epelectric.com); AEP Texas (aeptexas.com); Public Utility Commission of Texas storm contacts (puc.texas.gov); FoodSafety.gov, Food Safety During Power Outage; Texas Department of Licensing and Regulation (electrician licensing, Occupations Code ch. 1305); ServicesInn electrician cost research (panel and surge-protector worked examples, verified November 17, 2026).
